You don t need to remove the door.
Can i remove laminate from kitchen cabinet doors.
The best way to do it is to use a heat gun to soften the adhesive and pull the laminate off in sections starting with the edging.
Just leave it in place on the cabinet.
You can do the following steps with the door or panel on but if you can unscrew it from the cabinet you might find that working with it can be much less awkward.
Put on safety goggles and rubber gloves.
Some mdf cabinets have a plastic coating and removing a plastic coating from kitchen cabinets is usually easier than removing a wood laminate.
As you pull laminate away from the cabinet it can snap and break into.
If the hinges are mounted on the inside you can remove the laminate without disassembling the cabinets.
With a hair dryer on the lowest heat setting blow hot air across the edge of the laminate and continue across the entire cabinet in a sweeping motion.
You can paint over the cabinet sides and face melamine but the doors are different.
If they are thermofoil or shrinkwrapped vinyl there are many posts on this site how to remove it and repaint.
1 if the peeling is substantial use the utility knife and hand scraper to gently remove the laminate from the substrate.
Just check the search bar at the top.
Wedge a putty knife between the veneer and the base material of the cabinet door on one of the corners.
Insert the putty knife there.
To start remove any exterior hardware from the kitchen cabinets.
2 scrape under the laminate with the putty knife to remove any debris blobs of glue chips or anything that would prevent.
But there is an alternative or two.
Ensure that the laminate is in good condition by repairing minor laminate damage or.
If the old veneer is peeling you have a head start.
Use a screwdriver to remove all hardware from the cabinets from which formica will be removed.
Here are a couple of links to get you started.
If laminate is cracked warped or peeling that damage can interfere with the bonding of paint to the cabinet.
If you have laminate cabinets then the wood beneath is a poor quality particle board.
However both are doable with patience and a steady supply of heat.
Don t try to repaint over the vinyl since it moves.